|
 | » How to insulate flat ceilings? 2012-01-07
Put on elbow and knee pads, with a dust mask and long-sleeved shirt. Crawl in the cavity with a piece of insulation. Mind where you put your weight. |
|
 | » How to insulate a garage ceiling? 2012-01-06
You will need to measure the width and length of your garage ceiling. That can be done using the floor because they are the same size. |
|
 | » How to insulate recessed lighting? 2012-01-05
Examine your recessed lighting fixture. If it is older, check and make sure any insulation if at all present, is three inches away from the lighting. If its insulation is any closer, your light could overheat. If you see no insulation, consider insul |
|
 | » How to insulate house for winter? 2012-01-04
Check the attic and ensure proper insulation and ventilation of air. If needed, add an extra layer of attic insulation as it prevents ice dams reduces the heat loss through your home?s cracks in the home. It will also reduce the mold build-up. |
|
 | » How to install window insulation film? 2012-01-03
For a double hung window, clean the sash bottom. With foam weatherstripping cut it to the appropriate length. |
|
 | » How to insulate plumbing water pipes? 2012-01-02
Open insulation sleeves up along their length using the slit to fit them around the pipe, with the seams down. Make sure you use sleeves that have inside diameters which match the outside parameters of the pipes you are insulating. |
|
 | » How to insulate metal ducts? 2011-12-30
Seal all connecting seams of your metal ducts with a metal duct tape. Using a rag, wipe off the first seam off to remove any dirt and debris. |
|
 | » How to insulate a garage door? 2011-12-29
Measure your garage door panels. Purchase polyurethane foam sheets from the local hardware store ? ask for assistance in choosing the right type. |
|
 | » How to insulate hot tub? 2011-12-27
Check the current insulation in the hot tub. If its shell, cabinet, floor underside and plumbing pipes are insulated, you might simply use a tub cover. |
|
 | » How to install spray foam insulation? 2011-12-22
Prepare the walls to be sprayed by covering all the electrical outlets and boxes with masking tape and keep the foam from penetrating them. |
|
 | » How to insulate a steel building? 2011-12-21
Attach the rigid foam sheets onto the interior surface of your metal walls, holding the sheets in place using foam adhesive. |
|
 | » How to insulate basement walls? 2011-11-29
Take the measurements of the wall, making a pencil mark every 4 feet. Those marks should show the placement of the 2-by-4s or furring strips which will be installed on the wall. You can alternatively mark the wall using strips of the painters tape. |
|
 | » How to insulate a ceiling? 2011-09-22
Go up to your attic to inspect the insulation. If the attic is fitted but you are able to clearly see joists, or there is a leak in your attic roof, you should install new insulation and you will soon have lower energy consumption. |
|
 | » How to install insulation? 2011-09-21
Make sure you have the needed tools at hand - tape measure, utility knife with spare blades, a squeeze-type stapler and straightedge. |
|
 | » How to insulate your attic? 2011-09-20
First, you should measure the thickness of the current insulation and multiply it by the R-value of the material to get an overall R-value. |
|
 | » How to install cellulose insulation? 2011-09-14
Two techniques are applied when it comes down to the installation of cellulose insulation: |
